Physics

Electricity

Question:

An electric heater is connected to the 230 V mains supply. A current of 8 A flows through the heater.
(a) How much charge flows around the circuit each second ?
(b) How much energy is transferred to the heater each second ?

Answer:

lakhmir singh physics class 10 Chapter 1 Electricity Q34 Page 12

previuos
next

Electricity

Q 1.

(a) How many milliamperes are there in 1 ampere ?
(b) How many microamperes are there in 1 ampere ?

Q 2.

Give two reasons why nichrome alloy is used for making the heating elements of electrical appliances.

Q 3.

How many electrons are flowing per second past a point in a circuit in which there is a current of 5 amp ?

Q 4.

On what factors does the resistance of a conductor depend ?

Q 5.

Name the law which relates the current in a conductor to the potential difference across its ends.

Q 6.

Keeping the potential difference constant, the resistance of a circuit is halved. By how much does the current change ?

Q 7.

How should the two resistances of 2 ohms each be connencted so as to produce an equivalent resistance of 1 ohm ?

Q 8.

Name the unit of electrical resistance and give its symbol.

Q 9.

What is the general name of the substances having infinitely high electrical resistance ?

Q 10.

A current of 5 amperes flows through a wire whose ends are at a potential difference of 3 volts. Calculate the resistance of the wire.

Q 11.

Distinguish between good conductors, resistors and insulators. Name two good conductors, two resistors and two insulators.

Q 12.

How does the resistance of a wire vary with its :
(a) area of cross-section ?
(b) diameter ?

Q 13.

Calculate the combined resistance in each case :
lakhmir-singh-physics-class-10-solutions-electricity-38(11)

Q 14.

What do you understand by the term “electric potential” ? (or potential) at a point ? What is the unit of electric potential ?

Q 15.

Give the law of combination of resistances in series.

Q 16.

How should the two resistances of 2 ohms each be connencted so as to produce an equivalent resistance of 1 ohm ?

Q 17.

A wire that has resistance R is cut into two equal pieces. The two parts are joined in parallel. What is the resistance of the combination ?

Q 18.

For the circuit shown in the diagram below :
lakhmir-singh-physics-class-10-solutions-electricity-38(17)
What is the value of :
(i) current through 6 Ωresistor ?
(ii) potential difference across 12 Ω resistor ?

Q 19.

What is the unit of electric charge ?

Q 20.

Define one coulomb charge.

Q 21.

What do the following symbols mean in circuit diagrams ?
lakhmir-singh-physics-class-10-solutions-electricity-1

Q 22.

The p.d. across a lamp is 12 V. How many joules of electrical energy are changed into heat and light when :
(a) a charge of 1 C passes through it ?
(b) a charge of 5 C passes through it ?
(c) a current of 2 A flows through it for 10 s ?

Q 23.

State the law of combination of resistances in parallel.

Q 24.

An electric bulb of resistance 20 Ω and a resistance wire of 4 Ω are connected in series with a 6 V battery. Draw the circuit diagram and calculate :
(a) total resistance of the circuit.
(b) current through the circuit.
(c) potential difference across the electric bulb.
(d) potential difference across the resistance wire.

Q 25.

Three resistors are connected as shown in the diagram.
lakhmir-singh-physics-class-10-solutions-electricity-38(16)
Through the resistor 5 ohm, a current of 1 ampere is flowing,
(i) What is the current through the other two resistors ?
(ii) What is the p.d. across AB and across AC ?
(iii) What is the total resistance ?

Q 26.

What is meant by saying that the electric potential at a point is 1 volt ?

Q 27.

How much work is done when one coulomb charge moves against a potential difference of 1 volt ?

Q 28.

What is the SI unit of potential difference ?

Q 29.

Fill in the following blanks with suitable words :
(a) Potential difference is measured in………….. by using a……………. placed in………… across a component.
(b) Copper is a good………….. Plastic is an……………

Q 30.

Which particles constitute the electric current in a metallic conductor ?

Q 31.

Which of the following equation shows the correct relationship between electrical units ?
1 A = 1 C/s or 1 C = 1 A/s

Q 32.

Why should the resistance of :
(a) an ammeter be very small ?
(b) a voltmeter be very large ?

Q 33.

A student made an electric circuit shown here to measure the current through two lamps.
(a) Are the lamps in series or parallel ?
(b) The student has made a mistake in this circuit.
What is the mistake ?
(c) Draw a circuit diagram to show the correct way to connect the circuit.
Use the proper circuit symbols in your diagram.
lakhmir-singh-physics-class-10-solutions-electricity-2

Q 34.

Name the physical quantity whose unit is “ohm”.

Q 35.

(a) What is meant by the “resistance of a conductor” ? Write the relation between resistance, potential
difference and current.
(b) When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Calculate the value of the resistance of the resistor.

Q 36.

(a) Why do electricians wear rubber hand gloves while working with electricity ?
(b) What p.d. is needed to send a current of 6 A through an electrical appliance having a resistance of 40 Ω ?

Q 37.

The graph between V and 1 for a conductor is a straight line passing through the origin.
Which law is illustrated by such a graph ?
What should remain constant in a statement of this law ?

Q 38.

A current of 200 mA flows through a 4 kΩ resistor. What is the p.d. across the resistor ?

Q 39.

Why are copper and aluminium wires usually used for electricity transmission ?

Q 40.

Why are the coils of electric irons and electric toasters made of an alloy rather than a pure metal ?

Q 41.

(a) Give two examples of substances which are good conductors of electricity. Why do you think they are
good conductors of electricity ?
Calculate the resistance of a copper wire 1.0 km long and 0.50 mm diameter if the resistivity of copper is 1.7 × 10-8 Ωm.

Q 42.

(a) Give one example to show how the resistance depends on the nature of material of the conductor.
(b) Calculate the resistance of an aluminium cable of length 10 km and diameter 2.0 mm if the resistivity of aluminium is 2.7 x 10-8Ωm.

Q 43.

Two resistors, with resistances 5 Ω and 10 Ω respectively are to be connected to a battery of emf 6 V so as to obtain :
(i) minimum current flowing (ii) maximum current flowing
(a) How will you connect the resistances in each case ? .
(b) Calculate the strength of the total current in the circuit in the two cases.

Q 44.

(a) What do the letters p.d. stand for ?
(b) Which device is used to measure p.d. ?

Q 45.

How much work is done in moving a charge of 2 C across two points having a potential difference of 12 V ?

Q 46.

(a) Name a device that helps to measure the potential difference across a conductor.
(b) How much energy is transferred by a 12 V power supply to each coulomb of charge which it moves around a circuit ?

Q 47.

By what name is the physical quantity coulomb/second called ?

Q 48.

What actually travels through the wires when you switch on a light ?

Q 49.

Compare how an ammeter and a voltmeter are connected in a circuit.

Q 50.

What is the current in a circuit if the charge passing each point is 20 C in 40 s ?