The atoms of copper contain electrons and the atoms of rubber also contain electrons. Then why does copper conduct electricity but rubber does not conduct electricity ?
Copper has free electrons that are loosely held by the nuclei of the atoms. These free electrons result in conduction of electricity.
The electrons present in rubber are strongly held by the nuclei of its atoms. So, rubber does not have free electrons to conduct electricity.
(a) How many milliamperes are there in 1 ampere ?
(b) How many microamperes are there in 1 ampere ?
How many electrons are flowing per second past a point in a circuit in which there is a current of 5 amp ?
Keeping the potential difference constant, the resistance of a circuit is halved. By how much does the current change ?
Give two reasons why nichrome alloy is used for making the heating elements of electrical appliances.
Name the law which relates the current in a conductor to the potential difference across its ends.
A wire that has resistance R is cut into two equal pieces. The two parts are joined in parallel. What is the resistance of the combination ?
What is the general name of the substances having infinitely high electrical resistance ?
A current of 5 amperes flows through a wire whose ends are at a potential difference of 3 volts. Calculate the resistance of the wire.
Distinguish between good conductors, resistors and insulators. Name two good conductors, two resistors and two insulators.
How should the two resistances of 2 ohms each be connencted so as to produce an equivalent resistance of 1 ohm ?
Three resistors are connected as shown in the diagram.
Through the resistor 5 ohm, a current of 1 ampere is flowing,
(i) What is the current through the other two resistors ?
(ii) What is the p.d. across AB and across AC ?
(iii) What is the total resistance ?
For the circuit shown in the diagram below :
What is the value of :
(i) current through 6 Ωresistor ?
(ii) potential difference across 12 Ω resistor ?
An electric heater is connected to the 230 V mains supply. A current of 8 A flows through the heater.
(a) How much charge flows around the circuit each second ?
(b) How much energy is transferred to the heater each second ?
How does the resistance of a wire vary with its :
(a) area of cross-section ?
(b) diameter ?
How should the two resistances of 2 ohms each be connencted so as to produce an equivalent resistance of 1 ohm ?
What do you understand by the term “electric potential” ? (or potential) at a point ? What is the unit of electric potential ?
The p.d. across a lamp is 12 V. How many joules of electrical energy are changed into heat and light when :
(a) a charge of 1 C passes through it ?
(b) a charge of 5 C passes through it ?
(c) a current of 2 A flows through it for 10 s ?
A piece of wire of resistance 20 Ω is drawn out so that its length is increased to twice its original length. Calculate the resistance of the wire in the new situation.
Two resistors, with resistances 5 Ω and 10 Ω respectively are to be connected to a battery of emf 6 V so as to obtain :
(i) minimum current flowing (ii) maximum current flowing
(a) How will you connect the resistances in each case ? .
(b) Calculate the strength of the total current in the circuit in the two cases.
How much work is done when one coulomb charge moves against a potential difference of 1 volt ?
(a) Name a device that helps to measure the potential difference across a conductor.
(b) How much energy is transferred by a 12 V power supply to each coulomb of charge which it moves around a circuit ?
Which of the following equation shows the correct relationship between electrical units ?
1 A = 1 C/s or 1 C = 1 A/s
Why should the resistance of :
(a) an ammeter be very small ?
(b) a voltmeter be very large ?
Keeping the resistance constant, the potential difference applied across the ends of a component is halved. By how much does the current change ?
(a) Define the unit of resistance (or Define the unit “ohm”).
What happens to the resistance as the conductor is made thinner ?
Keeping the potential difference constant, the resistance of a circuit is doubled. By how much does the current change ?
The graph between V and 1 for a conductor is a straight line passing through the origin.
Which law is illustrated by such a graph ?
What should remain constant in a statement of this law ?
A p.d. of 10 V is needed to make a current of 0.02 A flow through a wire. What p.d. is needed to make a current of 250 mA flow through the same wire ?
(a) Give two examples of substances which are good conductors of electricity. Why do you think they are
good conductors of electricity ?
Calculate the resistance of a copper wire 1.0 km long and 0.50 mm diameter if the resistivity of copper is 1.7 × 10-8 Ωm.
What would be the effect on the resistance of a metal wire of :
(a) increasing its length ?
(b) increasing its diameter ?
(c) increasing its temperature ?
Show how you would connect two 4 ohm resistors to produce a combined resistance of
(a) 2 ohms
(b) 8 ohms.
Fill in the following blanks with suitable words :
(a) Potential difference is measured in………….. by using a……………. placed in………… across a component.
(b) Copper is a good………….. Plastic is an……………
In 10 s, a charge of 25 C leaves a battery, and 200 j of energy are delivered to an outside circuit as a result.
(a) What is the p.d. across the battery ?
(b) What current flows from the battery ?
A student made an electric circuit shown here to measure the current through two lamps.
(a) Are the lamps in series or parallel ?
(b) The student has made a mistake in this circuit.
What is the mistake ?
(c) Draw a circuit diagram to show the correct way to connect the circuit.
Use the proper circuit symbols in your diagram.
