Pressure is determined as force per unit area of the surface. The S.I. unit of pressure, pascal, is as shown below:1 Pa = 1 Nm-2.If mass of air at sea level is 1034 g cm-2,calculate the pressure in pascal.
Pressure is the force (i.e., weight) acting per unit area But weight = mg
Give an example of a molecule in which the ratio of the molecular formula is six times the empirical formula.
Calculate the amount of carbon dioxide that could be produced when
(i) 1 mole of carbon is burnt in air.
(ii) 1 mole of carbon is burnt in 16 g of dioxygen.
(iii) 2 moles of carbon are burnt in 16 g of dioxygen.
How much copper can be obtained from 100 g of copper sulphate (CuSO4 )? (Atomic mass of Cu= 63.5 amu)
Round up the following upto three significant figures:
(i) 34.216 (ii) 10.4107 (iii) 0.04597 (iv) 2808
The density of water at room temperature is 1.0 g/mL. How many molecules are there in a drop of water if its volume is 0.05 mL?
Pressure is determined as force per unit area of the surface. The S.I. unit of pressure, pascal, is as shown below:1 Pa = 1 Nm-2.If mass of air at sea level is 1034 g cm-2,calculate the pressure in pascal.
In the reaction, A + B2——> AB2, identify the limiting reagent, if any, in the following mixtures
(i) 300 atoms of A + 200 molecules ofB
(ii) 2 mol A + 3 mol B
(iii) 100 atoms of A + 100 molecules ofB
(iv) 5 mol A + 2.5 mol B
(v) 2.5 mol A + 5 mol B
What is the molecular mass of a substance each molecule of which contains 9 atoms of carbon, 13 atoms of hydrogen and 2.33 x 10-23 g other component?
Use the data given in the following table to calculate the molar mass of naturally occurring argon.
Calculate the concentration of nitric acid in moles per litre in a sample which has a density 1.41 g mL-1 and the mass percent of nitric acid in it is being 69%.
Calculate the mass of sodium acetate (CH3COONa) required to make 500 mL of 0.375 molar aqueous solution. Molar mass of sodium acetate is 82.0245 g mol-1
Determine the molecular formula of an oxide of iron in which the mass percent of iron and oxygen are 69.9 and 30.1 respectively. Given that the molar mass of the oxide is 159.8 g mol-1(Atomic mass: Fe = 55.85, O = 16.00 amu)Calculation of Empirical Formula.
KCl03 on heating decomposes to give KCl and 02. What is the volume of 02 at N.T.P liberated by 0.1 mole of KCl03?
Chlorine is prepared in the laboratory by treating manganese dioxide (Mn02) with aqueous hydrochloric acid according to the reaction.
4 HCl (aq) + Mn02 (s) ———–> 2 H2O (l) + MnCl2(aq) +Cl2(g)
How many grams of HCl react with 5.0 g of manganese dioxide? (Atomic mass of Mn = 55 u)
Determine the empirical formula of an oxide of Iron which has 69.9 % iron and 30.1 % dioxygen by mass.
Calculate the molarity of a solution of ethanol in water in which the mole fraction of ethanol is 0.040.
Express the following in scientific notation:
(i) 0.0048 (v) 6.0012 (ii) 234,000 (iii) 8008 (iv) 500.0
What is the concentration of sugar (C12H22O11) in mol L -1 if its 20 g are dissolved in enough water to make a final volume up to 2 L?
The Vapour Density of a gaseous element is 5 times that of oxygen under similar conditions. If the molecule is triatomic, what will be its atomic mass?
A sample of drinking water was found to be severely contaminated with chloroform, CHCly supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).
(i) Express this in percent by mass
(ii) Determine the molality of chloroform in the water sample.
Dinitrogen and dihydrogen react with each other to produce ammonia according to the following chemical equation:(i) N2 (g) + 3H2(g) —–> 2NH3 (g)
(ii) Will any of the two reactants remain unreacted?
(iii) If yes, which one and what would be its mass?
If ten volumes of dihydrogen gas reacts with five volumes of dioxygen gas, how many volumes of water vapour could be produced?
How many significant figures are present in the following?
(i) 0.0025 (ii) 208 (iii) 5005 (iv) 126,000
(v) 500.0 (vi) 2.0034
Calcium carbonate reacts with aqueous HCl according to the reaction
CaC03 (s) + 2HCl (aq) ———->CaCl2 (aq) +C02(g) +H2O(l).
What mass of CaC03 is required to react completely with 25 mL of 0.75 M HCl?
In three moles of ethane (C2H6), calculate the following:
(i) Number of moles of carbon atoms (ii) Number of moles of hydrogen atoms
(iii) Number of molecules of ethane
If the density of methanol is 0.793 kg L -1, what is its volume needed for making 2.5 L of its 0.25 M solution?
