What type of substances would make better permanent magnets, ferromagnetic or ferrimagnetic. Justify your answer.
Ferromagnetic substances make better permanent magnets. This is because when placed in magnetic field, their domains get oriented in the directions of magnetic field and a strong magnetic field is produced. This ordering of domains persists even when external magnetic field is removed. Hence, the ferromagnetic substance becomes a permanent magnet.
Explain how vacancies are introduced in an ionic solid when a cation of higher valence is added as an impurity in it.
‘Stability of a crystal is reflected in the magnitude of its melting points’. Comment. Collect melting points of solid water, ethyl alcohol, diethyl ether and methane from a data book. What can you say about the intermolecular forces between these molecules?
The total number of tetrahedral voids in the face centered unit cell is
(a) 6 (c) 10
(b) 8 (d) 12
Explain how many portions of an atom located at
(i)corner and (ii)body centre of a cubic unit cell is part of its neighbouring unit cell.
Ionic solids, which have anionic vacancies due to metal excess defect, develop colour. Explain with the help of a suitable example.
Copper crystallises into a fee lattice with edge length 3.61 x 10-8 cm. Show that the calculated density is in agreement with its measured value of 8.92 gcm-3.
Classify each of the following as being either a p-type or n-type semiconductor :
Gold (atomic radius = 0.144 nm) crystallises in a face centred unit cell. What is the length of the side of the unit cell ?
Solid A is a very hard electrical insulator in. solid as well as in molten state and melts at extremely high temperature. What type of solid is it?
A cubic solid is made up of two elements P and Q. Atoms of Q are at the corners of the cube and P at the body centre. What is the formula of the compound? What are the coordination numbers of P and Q?
If the radius of the octahedral void is r and radius of the atoms in close-packing is R, derive relation between rand R.
Which of the following statements are not true?
(a) Vacancy defect results in a decrease in the density of the substance
(b) Interstitial defects results in an increase in the density of the substance
(c) Impurity defect has no effect on the density of the substance
(d) Frenkel defect results in an increase in the density of the substance
The number of tetrahedral voids per unit cell in NaCl crystal is
(c) twice the number of octahedral voids
(d) four times the number of octahedral voids
In which of the following arrangements octahedral voids are formed?
(a) hep (b) bcc (c) simple cubic (d) fee
Explain how vacancies are introduced in an ionic solid when a cation of higher valence is added as an impurity in it.
How many lattice points are there is one unit cell of each of the following lattices?
(i) Face centred cubic (if) Face centred tetragonal (iii) Body centred cubic
What are semi-conductors? Describe the two main types of semiconductors and contrast their conduction mechanisms.
Copper crystallises into a fee lattice with edge length 3.61 x 10-8 cm. Show that the calculated density is in agreement with its measured value of 8.92 gcm-3.
Which of the following is not the characteristic of ionic solids?
(a) Very low value of electrical conductivity in the molten state
(b) Brittle nature
(c) Very strong forces of interactions
(d) Anisotropic nature
In the cubic close packing, the unit cell has
(a) 4 tetrahedral voids each of which is shared by four adjacent unit cells
(b) 4 tetrahedral voids within the unit cell
(c) 8 tetrahedral voids each of which is shared by four adjacent unit cells
(d) 8 tetrahedral voids within the unit cells.
A compound is formed by two elements M and N. The element N forms ccp and atoms of the element M occupy 1/3 of the tetrahedral voids. What is the formula of the compound? (C.B.S.E. Foreign 2015)
A compound forms hexagonal close-packed. structure. What is the total number of voids in 0. 5 mol of it? How many of these are tetrahedral voids?
Classify each of the following solids as ionic, metallic, modular, network (covalent) or amorphous:
(i) Tetra phosphorus decoxide (P4O10) (ii) Ammonium phosphate, (NH4)3P04 (iii) SiC (iv) I2 (v) P4 (vii) Graphite (viii), Brass (ix) Rb (x) LiBr (xi) Si
How will you distinguish between the following pairs of terms:
(i) Cubic close packing and hexagonal close packing?
(ii) Crystal lattice and unit cell?
(iii) Tetrahedral void and octahedral void?
Why does the electrical conductivity of semiconductors increase with rise in temperature?
What is the two-dimensional coordination number of a molecule in a square close-packed layer?
Wh ich of the following lattices has the highest packing efficiency (i) simple cubic (ii) body-centered cubic and (iii) hexagonal close-packed lattice?
What type of defect can arise when a solid is heated? Which physical property is affected by it and in what way?
What makes glass different from a solid such as quartz? Under what conditions could quartz be converted into glass?
A cubic solid is made of two elements P and Q. Atoms Q are at the corners of the cube and P at the body centre. What is the formula of the compound ? What is the co-ordination number of P and Q?
Analysis shows that nickel oxide has the formula Ni0.98 O1.00. What fractions of nickel exist as Ni2+ and Ni3+ ions?
Which of the following lattices has the highest packing efficiency (i) simple cubic (ii) body- centred cubic and (iii) hexagonal close-packed lattice?
What makes a glass different from a solid such as quartz? Under what conditions could quartz be converted into glass?
Iodine molecules are held in the crystals lattice by
(a) London forces (b) dipole-dipole interactions
(c) covalent bonds (d) coulombic forces
In which of the following structure coordination number for cations and anions in the packed structure will be same?
(a) Cl– ions form fee lattice and Na+ ions occupy all octahedral voids of the unit cell.
(b) Ca2+ ions form fee lattice and F- ions occupy all the eight tetrahedral voids of the unit cell
(c) O2- ions form fee lattice and Na+ ions occupy all the eight tetrahedral voids of the unit cell
(d) S2- ions form fee lattice and Zn2+ ions go into alternate tetrahedral voids of the unit cell.
Which of the following is not true about voids formed in three dimensional hexagonal close packed structure?
(a) A tetrahedral void is formed when a sphere of the second layer is present above triangular void in the first layer
(b) All the triangular voids are not covered by the spheres of the second layer
(c) Tetrahedral voids are formed when the triangular voids in the second layer lie above the triangular voids in the first layer and the triangular voids in the first layer and the triangular shapes of these voids do not overlap
(d) Octahedral voids are formed when the triangular voids in the second layer exactly overlap with similar voids in the first layer.
The value of magnetic moment is zero in the case of antiferromagnetic substances because the domains …
(a) get oriented in the direction of the applied magnetic field
(b) get oriented opposite to the direction of the applied magnetic field
(c) are oppositely oriented with respect to each other without the application of magnetic field
(d) cancel out each other's magnetic moment
Under the influence of electric field, which of the following statements are true about the movement of electrons and holes in a p-type semiconductor?
(a) Electron will move towards the positively charged plate through electron holes
(b) Holes will appear to be moving towards the negatively charged plate
(c) Both electrons and holes appear to move towards the positively charged plate
(d) Movement of electrons is not related to the movement of holes
An excess of potassium ions makes KCl crystals appear violet or Lilac in colour since
(a) some of the anionic sites are occupied by an unpaired electron
(b) some of the anionic sites are occupied by a pair of electrons
(c) there are vacancies at some’anionic sites
(d) F-centres are created which impart colour to the crystals
Amorphous solids can also be called
(a) pseudo solids (b) true solids
(c) super cooled liquids (d) super cooled solids
